Table of Contents Table of Contents English ... 1. Before You Start 2. Hardware Installation ... 3. Web Management Utility ... Troubleshooting ... Version 04.28.2006...
1. Before You Start System Requirements Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above) Computer with Network adapter installed Application 16-Port 10/100/1000Mbps Gigabit Web Smart Switch (TEG-160WS) 24-Port 10/100/1000Mbps Gigabit Web Smart Switch (TEG-240WS) Workstations with 10/100Mbps Ethernet Card (TE100-PCIWN)
2. Hardware Installation Note: After hardware installation is complete, use the Web-based Smart Utility to configure the TEG-160WS/TEG-240WS. To access the Web-based Smart Utility, open your web browser, and enter the default IP Address http://192.168.0.1 and default password "admin". Make sure your computer and the TEG-160WS/TEG-240WS are configured to the same network segment.
3. Web Management Utility ote: If you would like to easily discover all the Web Management Switches on the network, assign IP Address, change the password, and upgrade to new firmware, then install the Web Management Utility. Follow the steps below. For Windows User 1.
Page 6
4. Click Discovery, and then double- click the Switch that appears in the Discovery List. 5. Click the Switch in the Monitor List and then click Configuration setting. 6. Configure the IP Address, Subnet mask, Gateway, and Password. Click Set.
Page 7
8. Click Web access. 9. Type in your Password and then click Login. For more information regarding the Web-based Smart Utility configuration and advanced settings, please refer to the User's Guide included on the Utility CD- ROM or TRENDnet's website at www.trendnet.com English...
TEG-160WS/TEG-240WS. The default IP Address of the Switch is 192.168.0.1 and the default password is admin. When I access the TEG-160WS/TEG-240WS using a web browser, I get a screen that tells me “only one user can login”. What should I do? Another computer is configuring the TEG-160WS/TEG-240WS.