Assign Dhcp Snooping To Vlan Interfaces - TRENDnet TEG-204WS User Manual

TRENDnet User's Guide
4. In the left hand panel, click Tools, click on Configuration, and click Save.
5. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2017 TRENDnet. All Rights Reserved.

Assign DHCP Snooping to VLAN interfaces

Security > DHCP Snooping > VLAN
In this section, you can define an existing VLAN to apply DHCP snooping.
1. Log into your switch management page (see
on page 7).
2. Click on Security, click on DHCP Snooping, and click on VLAN.
3. In the field, enter the existing VLAN ID to apply DHCP Snooping. Then click Add to add
the VLAN entry to the table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
4. In the left hand panel, click Tools, click on Configuration, and click Save.
5. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-204WS
"Access your switch management page"
72