[Remote2 Mode]; [Function Button] - Panasonic PT-RQ13K Operating Instructions Manual

3) Press as to select [RESPONSE(ID ALL)].
4) Press qw to switch the item.
[ON]
[OFF]
5) Press as to select [GROUP].
6) Press qw to switch the item.
[A] - [Z]
7) Press as to select [RESPONSE(ID GROUP)].
8) Press qw to switch the item.
[ON]
[OFF]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to "NONE".

[REMOTE2 MODE]

You can set the <REMOTE 2 IN> terminal.
1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f When [USER] is selected, proceed to Step 3).
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.

[FUNCTION BUTTON]

Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[MULTI DISPLAY]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns the response when an ID is designated as ALL.
Does not return the response when an ID is designated as ALL.
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
Returns the response when an ID is designated as GROUP.
Does not return the response when an ID is designated as GROUP.
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 208)
Changes the setting of the <REMOTE 2 IN> terminal.
Disables the <FUNCTION> button.
Switches the [MULTI DISPLAY MODE] setting. (x page 150)
Displays the sub memory list. (x page 155)
Switches the [SYSTEM SELECTOR] setting. (x page 87)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 85)
Temporarily pauses the image. (x page 126)
Displays the waveform of the input signal. (x page 126)
Loads the registered lens memory. (x page 144)
ENGLISH - 143