Switching The Input - Panasonic PT-RQ13K Operating Instructions Manual

Switching the input

The input for projection can be switched. Method to switch the input is as follows.
f Press the input selection button on the remote control and directly specify the input to project.
f Press the input selection button on the control panel and directly specify the input to project.
f Display the input selection screen and select the input to project from the list.
Switching the input directly with the remote control
The input for projection can be switched by directly specifying it with the input selection button on the remote
control.
1) Press the input selection button (<DIGITAL LINK>, <DVI-D>, <HDMI>, <SLOT 1>, <SLOT 2>, <SDI>).
<DIGITAL LINK>
<DVI-D>
<HDMI>
<SLOT 1>
<SLOT 2>
<SDI>
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input
can also be changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
f <DVI-D> button, <HDMI> button, <SLOT 1> button, and <SLOT 2> button can be used when the optional Interface Board equipped with
corresponding input is installed in the slot.
f The operation when the <DVI-D> button, <HDMI> button, <SLOT 1> button, <SLOT 2> button, or <SDI> button is pressed can be fixed to
operation to switch to the input set in the [SECURITY] menu → [CONTROL DEVICE SETUP].
Switching the input directly with the control panel
The input for projection can be switched by directly specifying it with the input selection button on the control
panel.
Chapter 3 Basic Operations — Projecting
Remote control
Switches the input to DIGITAL LINK.
Switches the input to DVI-D.
This can be operated when the optional Interface Board equipped with the DVI-D input is installed in
the slot.
The input is switched every time the button is pressed when one of the DVI-D inputs is selected on
the installed optional Interface Board.
Switches the input to HDMI.
This can be operated when the optional Interface Board equipped with the HDMI input is installed in
the slot.
The input is switched every time the button is pressed when one of the HDMI inputs is selected on
the installed optional Interface Board.
Switches the input to the signal of the optional Interface Board installed in <SLOT 1>.
The input is switched every time the button is pressed when one of the inputs is selected on the
installed optional Interface Board.
Switches the input to the signal of the optional Interface Board installed in <SLOT 2>.
The input is switched every time the button is pressed when one of the inputs is selected on the
installed optional Interface Board.
Switches the input to SDI1, SDI2, SDI3, or SDI4 installed on the projector as standard.
The input is switched every time the button is pressed when one of the SDI inputs equipped on the
projector as standard is selected.
All the SDI inputs including the SDI input equipped on the projector as standard and the SDI input on
the installed optional Interface Board are switched when an optional Interface Board equipped with
the SDI input is installed in the slot.
Control panel
ENGLISH - 69