[Quad Pixel Drive] - Panasonic PT-RQ13K Operating Instructions Manual

2) Press the <ENTER> button.
f The [FRAME CREATION] screen is displayed.
3) Press as to select [FRAME CREATION MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[1]
[2]
[3]
Note
f The effect may be difficult to notice depending on the image.
f Switch the setting when the image looks unnatural due to delay of image or generation of noise.
f [FRAME CREATION] is fixed to [OFF] in the following cases.
g When [FRAME RESPONSE] is set to [FAST]
g When the [DISPLAY OPTION] menu → [SIMUL INPUT SETTING] is set to [AUTO(x2-speed)] or [AUTO(x4-speed)] and displaying an
image in simultaneous format
g While in the four-screen display mode
The four-screen display mode can be canceled by setting the [MULTI DISPLAY] menu → [MULTI DISPLAY MODE] to [OFF].
(x page 150)
g When the internal test patter is displayed.
f The [FRAME CREATION] setting is disabled and fixed to [OFF] when [FRAME CREATION] is set to anything other than [OFF] and the
following setting or operation is performed.
g Set [FRAME RESPONSE] to [FAST].
g Set the [DISPLAY OPTION] menu → [SIMUL INPUT SETTING] to [AUTO(x2-speed)] or [AUTO(x4-speed)] and display an image in
simultaneous format.
g Set the [MULTI DISPLAY] menu → [MULTI DISPLAY MODE] to anything other than [OFF] and display the four-screen display.
Setting [FILM DETECTION]
Set the film detection function to enhance the video resolution by determining if it is a content that the telecine is
performed on the input signal.
1) Press as to select [FRAME CREATION].
2) Press the <ENTER> button.
f The [FRAME CREATION] screen is displayed.
3) Press as to select [FRAME CREATION MODE].
4) Press qw to select a mode from [1], [2], or [3].
5) Press as to select [FILM DETECTION].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f The video resolution is not changed even if [FILM DETECTION] is set to [ON] for the contents that the telecine is not performed on the input
signal.
The contents which telecine is performed is the contents that the film image is converted to the video image.
f [FILM DETECTION] cannot be set when a signal for the content with vertical scanning frequency of 30 Hz, 25 Hz, or 24 Hz is input.

[QUAD PIXEL DRIVE]

Set the enable/disable of the QUAD PIXEL DRIVE function to enhance the resolution of the projected image.
1) Press as to select [QUAD PIXEL DRIVE].
98 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Disables the frame creation function.
Sets the amount of interpolation weaker.
Sets the amount of interpolation midway.
(Factory default setting)
Sets the amount of interpolation stronger.
Disables the film detection function.
Enables the film detection function. The video resolution is enhanced for the contents that telecine is
performed on the input signal.