Setting the communication condition of the <SERIAL OUT> terminal
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [(OUT) BAUDRATE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
5)
Press as to select [(OUT) PARITY].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Setting the response
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [RESPONSE(ID ALL)].
4)
Press qw to switch the item.
[ON]
[OFF]
5)
Press as to select [GROUP].
6)
Press qw to switch the item.
[A] - [Z]
7)
Press as to select [RESPONSE(ID GROUP)].
8)
Press qw to switch the item.
[ON]
[OFF]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using the serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) connected to the <DIGITAL LINK IN/
LAN> terminal of the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) installed in the slot) is connected.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to "NONE".
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1)
Press as to select [REMOTE2 MODE].
174 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select the proper speed.
Select the parity condition.
Returns the response when an ID is designated as ALL.
Does not return the response when an ID is designated as ALL.
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
Returns the response when an ID is designated as GROUP.
Does not return the response when an ID is designated as GROUP.