[Remote2 Mode]; [Function Button]; [Status] - Panasonic PT-REQ10 Operating Instructions Manual

[REMOTE2 MODE]

You can set the <REMOTE 2 IN> terminal.
1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.

[FUNCTION BUTTON]

Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
[ANGLE MONITOR]
4) Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
182 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 289)
Changes the setting of the <REMOTE 2 IN> terminal.
Disables the <FUNCTION> button.
Displays the sub memory list. (x page 198)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input is SDI
g The [DISPLAY OPTION] menu → [SLOT IN] → [SYSTEM SELECTOR]
f When the input is SDI OPT1 / SDI OPT2 of Function Board
g The [DISPLAY OPTION] menu → [SLOT IN] → [SDI OPT1] / [SDI OPT2] → [SYSTEM
SELECTOR]
f When the input is anything other than SDI / SDI OPT1 / SDI OPT2
g The [PICTURE] menu → [SYSTEM SELECTOR]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 103)
Temporarily pauses the image. (x page 149)
Displays the waveform of the input signal. (x page 149)
Loads the registered lens memory. (x page 154)
Switch the aspect ratio of the image. (x page 109)
Switches the [PROJECTION METHOD] setting. (x page 152)
Switches the [GEOMETRY] setting. (x page 111)
Displays the [ANGLE MONITOR] screen. (x page 186)