Panasonic PT-RQ13K Operating Instructions Manual page 29

r Connecting terminals
6
7
1 <REMOTE 1 IN> terminal/<REMOTE 1 OUT> terminal
These are terminals to connect the remote control for serial
control in a multiple projector environment.
2 <REMOTE 2 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
3 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
4 <SERIAL OUT> terminal
This is a terminal to output the signal connected to the <SERIAL
IN> terminal.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
Chapter 1 Preparation — About your projector
1 2
8
3 4
9
5 <FRAME SYNC 1 IN/OUT> terminal/<FRAME SYNC 2 OUT>
terminal
These are terminals to input and output the control signal
to synchronize the projected images in a multiple projector
environment.
The projected images of second and subsequent projectors can
be synchronized to the first projector when the same image is
projected simultaneously.
6 Slots (<SLOT 1>, <SLOT 2>)
There are SLOT NX-specification slots to install the optional
Interface Board internally.
7 Slot cover
8 <DIGITAL LINK/LAN> terminal
This is the LAN terminal to connect to the network. This is also
used when connecting a video signal transmission device via
the LAN terminal.
9 <SDI IN 1> terminal/<SDI IN 2> terminal/<SDI IN 3>
terminal/<SDI IN 4> terminal
These are terminals to input SDI signals.
5
ENGLISH - 29