Table of Contents
Advertisement
The Installation Menu
The Installation menu is used for installing the projector.
Setting items
Screen Fitting
*1
V Keystone
*1
H Keystone
*1
Corner Keystone
Image Flip
High Altitude Mode
Filter Cleaning
*3*4*5
Digital Shrink
*6
Panel Alignment
*7
Color Matching
Notes
*1: Since the HV Keystone/Corner Keystone adjustment is an electronic correction, the image may deteriorate.
*2: Normally, filter cleaning is performed automatically. However, it is not performed when the projector is installed at an angel
within the range illustrated below.
*3: Since Digital Shrink uses electronic correction, the image may deteriorate.
*4: If you press the ENTER button while adjusting with Digital Shrink, the projector switches to the shift adjustment.
*5: The function is available when "Aspect" is set to an item other than "4:3".
*6: Depending on the adjustment value of "Panel Alignment," the color and resolution may be changed.
*7: The brightness and color of the projected image may not match completely, even after you adjust "Brightness" and "Color."
Item descriptions
HV Keystone/ Corner Keystone: You can choose how to correct image twist.
This is displayed when "HV Keystone" is selected in "Screen Fitting."
The higher the setting, the narrower the top of the projected image. The lower the setting,
the narrower the bottom of the projected image.
This is displayed when "HV Keystone" is selected in "Screen Fitting."
The higher the setting, the narrower the right side of the projected image. The lower the
setting, the narrower the left side of the projected image.
This is displayed when "Corner Keystone" is selected in "Screen Fitting."
Adjust: Corrects image twist.
Reset: Resets the adjusted values to their default values.
HV/H/V/Off/Auto: Flips the projected image horizontally and/or vertically according to
the installation method.
On/Off: Set to "On" when using the projector at an altitude of 1,500 m or higher.
Continuing to use the wrong setting may affect component reliability.
Turns off the projector and cleans the air filter.
Shrinks or adjusts the size of the projected image.
Digital Shrink: Adjusts the size of the projected image. If you set the value to "0", the
image is set to the original size. The shrinking rate is 100% to 90%.
Shift: Adjusts the position of the projected image. The adjustable range varies from the
shrinking rate.
This feature allows you to adjust the gaps in the color of characters or the picture.
When set to "On," "Adjust Color" and "Pattern Color" can be assigned and adjusted.
Adjust Item: Selects how to make adjustments from below.
Shift: Shifts the whole picture and makes adjustments.
Zone: Selects the desired range and makes adjustments.
Adjust Color: Assigns the desired color to adjust the gaps in color. Select "R" (Red) or "B"
(Blue) to make adjustments based on "G" (Green).
Pattern Color: Select "R/G" (Red and Green) or "R/G/B" (White, all colors) when "Adjust
Color" is "R" (Red). Select "B/G" (Blue and Green) or "R/G/B" (White, all colors) when the
"Adjust Color" is "B" (Blue).
Adjust: The shift adjustment and zone adjustment of the color selected in "Adjust Color"
can be made with /// keys.
Reset: The panel alignment settings are initialized to their factory preset values.
Adjust/Reset: For correcting the brightness and color of the whole projected image
manually from the signal level in six steps.
*2
27
Advertisement
Table of Contents
