Table of Contents
Advertisement
1
Click on [Owner information] to enter the owner
information recorded in the e-mail report.
Owner information button
2
Set the timing of the e-mail report.
Click on [Mail Report] to open the Mail Report page.
Start E-mail Service:
Set the E-mail function to enabled or disabled.
Light Source 1:
Set an arbitrary timing of the email report for using the
light.
Light Source 2:
This unit is not supported.
Maintenance:
Set the timing of the email report for maintenance. To
reset Maintenance Reminder, check the RESET check
box and then click on [Apply].
Mail Report button
2
3
4
6
5
3
Enter the outgoing e-mail address in the Email
Address box then check the Report Timing check box
of the e-mail report to be sent.
4
Set the mail account for sending e-mail reports.
Mail Address:
Enter the e-mail address.
Outgoing Mail Server (SMTP):
Enter the address of outgoing mail server (SMTP).
Required Authentication:
Check this check box if authentication is required for
sending e-mail.
Requires the use of POP Authentication before
sending email (POP before SMTP):
Check this check box to arrange for POP
authentication to be performed before sending e-
mail.
Incoming Mail Server (POP3):
Enter the address of the incoming-mail server (POP3)
to be used for POP authentication.
Account Name:
Enter the mail account name.
Password:
Enter the password.
SMTP Authentication:
Check this check box to arrange for SMTP
authentication to be performed before sending e-
mail.
Account Name:
Enter the mail account name.
Password:
Enter the password.
5
Confirm the contents of the e-mail report.
When you click on [View], the contents of the e-mail
report are displayed.
6
Send the test mail.
Check on the Send test mail check box then click on
[Apply] to send your test mail to the e-mail address you
set.
Notes
• The email report function will not work if the network
uses Outbound Port25 blocking, which prevents access to
the SMTP server.
• You cannot use the following characters to enter the
characters in the text box: " ' ", " " ", " \ ", " & ", " < ", " > "
Setting the LAN Network of the projector
Set the LAN network function on the Setup page.
Entered values will not be applied unless you click
on [Apply].
31
Advertisement
Table of Contents
