Error Handling; Indicators - Sony VPL-PHZ12 Operating Instructions Manual

Error Handling

Indicators

You can check the projector status or abnormality by checking the lighting/flashing status of the ON/
STANDBY indicator and WARNING indicator on the front. If the indicators flash in red, address the problem
in accordance with "Warning indicators and remedies" (page 44).
Operating status indication
Indicator status Operating status
Standby
(Lights in red) (Off)
Warm-up
(Flashes in green) (Off)
Power on
(Lights in green) (Off)
Other standby status
(Lights in orange) (Off)
Warning indicators and remedies
Indicator status The number of flashes
Twice
Three times
(Lights (Flashes
in red) in red)
Six times
ON/STANDBY WARNING
indicator indicator
Meaning
The power is supplied to the projector and the projector is in a standby
mode according to the setting.
The projector is warming up after it is turned on.
The projector is ready for projection.
The projector is in With No Input (Light Cutoff), Quick Reboot standby
mode, or the Speaker Setting is set to "Always On."
Meaning/Remedies
The air filter is not installed securely.
Check how the air filter is attached and install securely.
The light source does not light properly.
Unplug the AC power cord and make sure the ON/STANDBY indicator
turns off, then plug the AC power cord into the wall outlet and turn on the
projector.
A strong shock to the projector is detected.
If there is no visible abnormality, unplug the AC power cord and make
sure the ON/STANDBY indicator turns off, then plug the AC power cord
into the wall outlet and turn on the projector.
44