Table of Contents
Advertisement
Adjusting the tilt of the projector with the front
feet (adjustable)
By changing the slope of the projector with front
feet (adjustable), you can adjust the position of
the projected image.
How to alter the angle
When the projector is installed on an uneven
surface, you can adjust using the front feet
(adjustable).
Notes
• Be careful not to let the projector down on your fingers.
• Do not push hard on the top of the projector with the
front feet (adjustable) extended. It may cause
malfunction.
Changing the aspect ratio of the projected image
Press the ASPECT key on the remote commander
to change the aspect ratio of the projected image.
You can also change the setting in Aspect of the
Screen menu (page 21, 22).
Correcting trapezoidal distortion of the projected
image (Keystone feature)
If the image becomes trapezoidal, set the
keystone manually.
When the projected image is a trapezoid, tapering to the
top or bottom
1
Press the KEYSTONE key on the remote commander
once or select "V Keystone" in the Installation menu.
2
Use the /// keys to set the value. The higher the
setting, the narrower the top of the projected image.
The lower the setting, the narrower the bottom.
Press the RESET key to restore the Projected image
before adjustment.
When the projected image is a trapezoid, tapering to the
right or left
1
Press the KEYSTONE key on the remote commander
twice or select "H Keystone" in the Installation menu.
2
Use the /// keys to set the value. The higher the
setting, the narrower the right part of the projected
image. The lower the setting, the narrower the left
part.
Increase the number
towards minus
Press the RESET key to restore the projected image
before adjustment.
Notes
• Since the Keystone adjustment is an electronic correction,
the image may be deteriorated.
• Depending on the position adjusted with the lens shift
feature, the aspect ratio of the image may change from
the original or projected image may be distorted with
Keystone adjustment.
• If adjusting upwards or downwards (V keystone
adjustment) and to the right or left (H keystone
adjustment) at the same time, the values of the
adjustment menu may not reach the maximum value.
• If you press the KEYSTONE key on the remote control to
switch the keystone adjustment and corner key stone
16
Increase the number
towards plus
Increase the number
towards minus
Increase the number
towards plus
Advertisement
Table of Contents
