Table of Contents
Advertisement
Installation Menu
The Installation menu is used for changing the installation settings.
Setting items
Image Flip
Lens Control
Trigger Select
IR Receiver
ID Mode
Description
Flips the picture on the screen horizontally and/or vertically.
HV: Flips the picture horizontally and vertically.
H: Flips the picture horizontally.
V: Flips the picture vertically.
Off: The picture does not flip.
Use this item for installation for the rear projection or ceiling installation.
Avoids any operation of the lens such as "Lens Focus," "Lens Zoom," and "Lens Shift," by mistake.
On: Enables adjustment of the lens.
Off: Prevents any adjustment of the lens.
Switches the output function of the TRIGGER 1/TRIGGER 2 connector.
Off: Turns off the TRIGGER connector function.
Power: Outputs 12 V signals from the TRIGGER 1/TRIGGER 2 connectors when the unit is on. The
TRIGGER 1/TRIGGER 2 connectors do not output any signals when the unit is in standby.
2.35:1 Zoom: Works with the "Aspect" setting's "2.35:1 Zoom" (page 24) and outputs a 12 V signal
from the TRIGGER 1 or TRIGGER 2 connector.
Selects the remote control detectors (IR Receiver) on the front and rear of the unit.
Front & Rear: Activates both the front and rear detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only.
All/1/2/3/4: Assigns an ID number to the projector. When set to "All," you can control the projector with
the remote control independently of the assigned ID Mode. Refer also to "ID MODE switch" of the
remote control (page 5).
29
Advertisement
Table of Contents
