Table of Contents
Advertisement
The Operation Menu
The Operation menu is used for setting for the operations by using the menu or the remote commander.
Setting items
Language
Menu Position
Status
IR Receiver
*1
Security Lock
Control Key Lock
Note
*1: You will not be able to use the projector if you forget your password. If you call qualified Sony personnel because you have
forgotten the password, you will be asked to verify the projector's serial number and your identity. (This process may differ in
other countries/regions.) Once your identity has been confirmed, we will provide you with the password.
Item descriptions
Selects the language used in the menu and on-screen displays.
Bottom Left/Center: For selecting the position of the menu displayed on the projected
image.
On: All on-screen statuses are enabled.
Off: Displays only the menus, the message when turning off the power, and warning
messages.
Front & Rear/Front/Rear: Selects the remote control receiver (IR Receiver) on the front and
rear of the projector.
On/Off: This function enables restriction of the projector to authorized users by password.
The setting procedures for security locking are as follows:
1 Select "On" and press the ENTER key to display the setting menu.
2 Input the password with the MENU, /// and ENTER keys. (The default setting
password is "ENTER, ENTER, ENTER, ENTER.")
3 Input a new password with the MENU, /// and ENTER keys.
4 Enter the password again to confirm.
Enter the password when you turn on the projector after disconnecting and reconnecting
the AC power cord.
When it is set to "Off," you can cancel the security lock. You are required to input the
password again.
If you fail to enter the correct password after three consecutive times, the projector cannot
be used. In this case, press the / key to go Standby mode then turn on the power again.
On/Off: When set to "On," locks all the control panel keys of the projector. However, you
can operate the following when set to "On":
Press and hold the / key for approximately 10 seconds during Standby mode.
The projector turns on.
Press and hold the MENU key for approximately 10 seconds during power on.
"Control Key Lock" is set to "Off" and enables operation of all keys on the projector.
24
Advertisement
Table of Contents
