Table of Contents
Advertisement
C2000 and C4000 Hardware Guide
CAUTION: Make sure that you open the ejector handle completely (you will hear it
click). This prevents damage to the SFP.
6.
7.
Figure 13: Removing SFPs
8.
9.
Installing an SFP
To install an SFP:
1.
2.
3.
4.
5.
6.
34
Installing or Replacing an SFP
Grasp the SFP ejector handle, and pull the SFP approximately 0.5 in (1.3 cm)
out of the interface port.
Using your fingers, grasp the body of the SFP, and pull it the rest of the way out.
Place a rubber safety cap over the transceiver.
Place the removed SFP on an antistatic mat or in an electrostatic bag.
Attach an ESD wrist strap to your bare wrist, and connect the wrist strap to an
appropriate grounding point.
Take each SFP to be installed out of its electrostatic bag, and identify the interface
where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover
the transceiver with a safety cap.
Carefully align the SFP with the interface. The connectors should face the chassis.
Slide the SFP until the connector is seated in the interface. If you are unable to
fully insert the SFP, make sure the connector is facing the right way.
Remove the rubber safety cap from the transceiver and the end of the cable.
Insert the cable into the transceiver.
Advertisement
Table of Contents
