Cabling The System; Cabling The Management Console; Management Ports - Juniper C Series Hardware Manual

Hide thumbs Also See for C Series:
Table of Contents

Advertisement

4.
5.

Cabling the System

Cabling the system requires the following main tasks:
1.
2.
3.
4.
5.
NOTE: We recommend that you use shielded cables where appropriate.
See "System Specifications" on page 39 for more information about system
specifications.

Cabling the Management Console

Before powering up the system, you must set up a management console. The console
enables you to communicate with your system during the power-up process and to
manage your system using the command-line interface (CLI).
When connecting a console directly to the system, use a cable appropriate for your
terminal connector. The cable must have a female DB-9 connector to attach to the
RS-232 port on the system.

Management Ports

The management section of the system has three ports for management access (see
Figure 7 on page 17 and Figure 9 on page 17):
The management port is considered a data terminal equipment (DTE) interface.
Direct connection to a terminal or PC (which also has DTE interfaces) requires a
crossover cable.
Starting at the bottom of the system, have the third person secure the system
in the equipment rack by using the 10-32 x 3/8 Phillips screws.
Connect the necessary cables.
Familiarize yourself with the ports, and ensure that you have the cables and
wires needed to complete each cabling procedure.
Read and understand all safety warnings. (See "Installation Guidelines and
Requirements" on page 59.)
Connect the system to the network and to a management console.
Connect the other interfaces to their appropriate network interface.
Connect the power cables from the power source to the system's power supply.
Two 10/100Base-T Ethernet ports Each accepts an RJ-45 (male) connector,
providing an out-of-band connection for LAN access through a Telnet session,
SSH, or SNMP.
One RS-232 management port Accepts a DB-9 (female) connector. This port
provides direct CLI access from a console terminal.
Chapter 3: Installing and Cabling the C Series Controller
Cabling the System
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2000C4000

Table of Contents