Regulatory Compliances; Safety Notices; Lithium Battery; Power Disconnection - Juniper C Series Hardware Manual

Hide thumbs Also See for C Series:
Table of Contents

Advertisement

C2000 and C4000 Hardware Guide
Choose a location for the system that is dry, relatively dust free, well ventilated, and
air conditioned. If you install equipment in a rack, be sure that the floor is capable
of supporting the combined weight of the rack and the installed equipment. Place
the system in a location with sufficient access to power and network cables.
Like other network devices, the system generates a significant amount of heat. You
must provide a balanced environment so that the system performs properly and
safely. See "System Specifications" on page 39 for acceptable ranges of temperature
and humidity.
Be sure to allow enough space around the system for adequate ventilation. Inadequate
ventilation can cause the system to overheat.
CAUTION: Do not block the air vents on the system. Otherwise, the system might
overheat.

Regulatory Compliances

See "System Specifications" on page 39 for a complete list of regulatory compliance
requirements, including safety, EMC, and telecommunications.

Safety Notices

For your safety, before installing the system, review all safety notices in this topic.

Lithium Battery

WARNING: There is a danger of explosion if the battery is incorrectly replaced. Return
the device to the manufacturer for battery replacement. Moreover, never open the
chassis under any circumstances. Doing so will also void the warranty.
WARNING: La batterie présente un risque d'explosion si elle n'est pas remplacée
comme il se doit. Retournez l'appareil au fabricant pour faire remplacer la batterie.
Le châssis ne doit par ailleurs en aucun cas être ouvert. Cela annulerait la garantie.

Power Disconnection

WARNING: Before working on a device that has an On/Off switch, turn the power
off and disconnect the power cord to all power supplies.
For DC power supplies, locate the circuit breaker on the panel board that services
the DC circuit, switch the circuit breaker to the off position, and tape the switch
handle of the circuit breaker in the off position.
60

Regulatory Compliances

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2000C4000

Table of Contents