Chosing The Program - Smeg UG411DSUK Manual

10 CHOSING THE PROGRAM

Scrolling through the programs available displays first the program name (in English) and hen the number
(P1, P2..... etc.) followed by the duration.
PROGRAM
GLASS Short
Glass Medium
GLASS Long
CUSTOM Program User
DISHES Short
DISHES Long
Cutlery
(*) The cycle duration stated above is guaranteed if the water intake temperature is as stated and
recommended in the "TECHNICAL DATA" table, and in all cases refers to the first cycle performed. For
repeated cycles, operating conditions may vary from installation to installation. If the dishwasher is
supplied with cold water, the cycle duration might increase depending on the intake water temperature
and the "thermostop" setting.
Power blackouts.
If the dishwasher is open when power is restored, the display will read "
element will remain off, to prevent the risk of burns to the user.
Close the dishwasher to resume heating the water in the tank.
Enabling/disabling the program name on the display
The display shows the program number P1, P2, P3 and name, Glass, Dishes, Cutlery etc. by default. You can
choose not to display the name of the program. In this case, only P1, P2, P3 etc. will be shown on the
display.
The procedure must be carried out with the machine switched off but powered.
Press and hold down the start / pause button.
When the vertical lines ||||| appear on the display, release the start / pause button and then press it
again immediately.
The procedure is complete; there is no audible or visual confirmation.
It is possible to check if the procedure has been carried out correctly when the machine is switched on
again.
TYPE OF DIRT
P1 Dirty soiled glasses
P2 Normally soiled glasses
P3 Heavily soiled glasses
P4 Customisable (see "set-up information")
P5 Lightly soiled plates
P6 Heavily soiled plates
P7 Intensive programm with 70°C washing
25
DURATION (*)
1 min
1 min 20s
2 min 30s
1- 10 min
1 min
1 min 30s
4 min 10s
°t
" and the heating