Table of Contents
Advertisement
USER program duration customisation (optional, only if installed)
Steam extraction time setting (optional if installed)
Service setting (for After-Sales Service only)
7.3 Starting the peristaltic pumps – rapid filling of detergent and rinse aid delivery
circuit.
Perform after the parameter modification procedure explained in the previous point
With the dishwasher powered up and the tank full, press the
on/off
button for a few seconds; when ------ appears on
the display, release the button and press it again quickly
within 0.5 seconds.
The peristaltic pumps continue to operate until the same
button is pressed again. The rinse aid and detergent symbol
lights flash alternately as long as the pumps are on; bear in
mind that the rinse aid peristaltic pump fills the circuit in
about 7 minutes, while for the detergent it only takes 2
minutes. So draw only rinse aid from the jerry cans (1 for the
rinse aid and the other for the detergent) for the first 5
minutes and then also take in detergent for the last 2.
On some models, the message
appear during the setup procedure. To reset the message, open the dishwasher door and
close it again. If the message persists, contact the after-sales service.
USER. is the only program which can be customised.
Scroll through the setup parameters to display USER.P1,
P2..... followed by two dashes (e.g. P2--). Keep pressing the P
button until USER appears followed by the duration
Steam extraction system operating time display and setting.
See information on Smegtech
(PCB self-diagnostics on dishwasher closure) may
"door"
18
(e.g. USER. 03.10).
Advertisement
Table of Contents
