Preparing The Appliance For Use; Positioning And Installation - Smeg UG411DSUK Manual

Table of Contents

5 PREPARING THE APPLIANCE FOR USE

Convey the dishwasher to the installation site, remove the packaging and check the appliance and

components for damage; any damage found must be reported to the transporter in writing. The packaging

components (plastic bags, expanded polystyrene, nails, etc.) must not be left within reach of children and

pets since they are potentially dangerous. All packaging materials used are environment-friendly. They can

be kept without constituting any hazard, or may be disposed of at a specialist waste disposal centre. The

plastic components suitable for recycling are marked as follows:

PE - polyethylene: external packaging film, bag containing the instructions, protective bags.

PP - polypropylene: straps used to close the packaging.

PS - expanded polystyrene: corner guards, top of packaging.

Wooden and cardboard components can be disposed of in accordance with the local regulations.

All operations described in this section must be carried out and/or checked by the qualified

staff who install and commission the dishwasher.

Place the dishwasher in the chosen point and remove the protective film. Level the dishwasher (with the

aid of a spirit level) on its four feet, adjusting them to ensure that it is stable. If the dishwasher is installed

above the ground, make sure that the stand and dishwasher are secured properly and do not constitute a

hazard.

The systems and premises in which the dishwasher is installed must comply with the relevant

regulations.

If the dishwasher is installed next to another appliance, also check the recommendations

provided by the manufacturer of the adjacent appliance.

Installations other than those described must first be approved by the manufacturer.

Use only professional furnishings and units in the vicinity of the dishwasher. Any other types

of furnishing may be damaged.

Table of Contents