Transfer Section; Detaching And Refitting The Transfer Roller Unit - Kyocera Mita KM-2560 Service Manual

2H0/2HZ
1-5-6

Transfer section

(1) Detaching and refitting the transfer roller unit

Follow the procedure below to replace the transfer roller unit.
Procedure
1. Open the left cover 1.
2. Remove the claws of the front and rear
transfer bushes and remove the transfer
roller unit.
3. Replace the transfer roller unit and install
the unit.
The front and rear transfer springs must be
firmly mounted on the holder.
1-5-40
Transfer roller unit
Front transfer bush
Left cover 1
Front transfer
bush
Claw
Claw
Front transfer
spring
Holder
Figure 1-5-74
Rear transfer bush
Rear transfer
bush
Claw
Claw
Rear transfer
spring
Holder