Kyocera Mita KM-2560 Service Manual page 92

2H0/2HZ
Maintenance
item No.
Setting the finisher
U246
Description
Provides various settings for the built-in finisher, if furnished.
Purpose
Adjusts the side registration cursor stop position if paper registration is poor or stapling is made outside the
specified area.
Setting
1. Press the start key.
2. Select the desired cursor position.
3. Change the setting using the +/- or numeric keys.
Display
FRONT
REAR
END
4. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the paper feed device
U247
Description
Turns on motor and clutches of optional paper feeder.
Purpose
To check the operation of motors and clutches of paper feeder.
Method
1. Press the start key.
2. Select the item to be operated.
Display
DESK FEED
CLUTCH FEED
CLUTCH U
CLUTCH L
3. Press the start key. The operation starts.
4. To stop operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-56
Description
Description
Front side registration cursor stop
position
Rear side registration cursor stop
position
Trailing edge registration cursor stop
position
Motor and clutches
Paper feeder drive motor (PFDM)
Paper feeder conveying clutch (PFCCL)
Paper feeder paper feed clutch 1 (PFPFCL1)
Paper feeder paper feed clutch 2 (PFPFCL2)
Setting Initial Change in
range setting value per step
-4 to +4 0 0.566 mm
-4 to +4 0 0.566 mm
-4 to +4 0 0.566 mm