Kyocera Mita KM-2560 Service Manual page 116

2H0/2HZ
Maintenance
item No.
Relay board maintenance
U935
Description
Sets the mode when call for service (C0060) occurs.
Purpose
Sets the machine status temporarily when call for service (C0060) occurs. However, after the setting, call for
service (C0060) occurs again when progress of period.
Setting
1. Press the start key.
2. Select the item.
Display
MODE 0
MODE 1
Initial setting: 0
3. Press the start key. The setting is set.
4. Turn the main power switch off and on.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.
Setting of deflection for feeding from DP
U942
Description
Adjusts the deflection generated when the optional DP is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the DP is used.
Setting
1. Press the start key.
2. Select the item to be adjusted.
Display
FEED MOT
REV MOT
3. Press the system menu key.
4. Place an original on the DP and press the start key to make a test copy.
5. Press the system menu key.
6. Change the setting value using the +/- or numeric keys.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling of original
occurs, decrease the value.
7. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-80
Description
Description
Setting mode: OFF
Setting mode: ON (Usable up to three times of use)
Description
Deflection in the original feed motor
Deflection in the original switchback
motor
Setting Initial Change in
range setting value per step
-31 to 31 0 0.098 mm
-31 to 31 0 0.098 mm