table of contents
Owner's Information
Decal Location .........................................................................5
Before You Start .....................................................................10
Warranty .....................................................................74
Installer's Information
Installation
Clearances ............................................................................19
Framing ..................................................................................22
Finishing ................................................................................24
On Demand Pilot (seven day safety timer)
Important information if using the appliance in CPI (continuous pilot
mode) only
This appliance is a ProFlame 2 system fitted with the "On Demand" Pilot, a safety
feature which will shut down the gas valve completely by extinguishing the pilot
light in the event of a continuous full seven days of inactivity.
This only applies if the CPI (continuous pilot) switch is in the "on" position in your
remote control transmitter.
Each time the main burner shuts down, manually or through the call from the
thermostat, the seven day timer starts again.
The seven day inactivity timer is controlled within the circuit board. Therefore, if
in CPI mode and when the pilot light is extinguished after seven straight days
of inactivity, the CPI setting on the remote control transmitter will remain in the
"CPI" (continuous pilot) position. Therefore, all that is required to relight the pilot
would be to press the on/off button on the remote control transmitter from "on"
to "off" and back to "on". Once the pilot has re-established operation will resume
as normal. There is no requirement to do anything with the IPI/CPI mode on the
remote control transmitter.
If the unit never goes as long as seven full days without a call for heat, the pilot
will remain lit until it is manually shut-off.
If the unit is being operated in IPI (intermittent pilot) mode, neither the above
instructions nor the seven day timer will apply.
See the instructions in this manual and on the Lighting Instructions plate on the
appliance to light or re-light the pilot.
|
4
P36E-11 Zero Clearance Direct Vent Gas Fireplace
System Data ..........................................................................44
Pilot Adjustment .....................................................................45
High Elevation ........................................................................45
Wiring Diagram ......................................................................59
First Fire ................................................................................63
Log Replacement ..................................................................66
Glass Gasket .........................................................................66
Door Glass .............................................................................66
Removing Valve .....................................................................67
Gas Maintenance ..................................................................68
Parts
Main Assembly ......................................................................69
Warranty
Warranty ................................................................................74
.................................................46