Proflame I Remote Receiver Battery Replacement - Regency Panorama P36E-NG11 Owners & Installation Manual

PROFLAME I REMOTE RECEIVER BATTERY REPLACEMENT & BATTERY BACKUP IF 120V
POWER IS LOST WITHIN HOME
Remote Receiver/Battery Holder Battery Replacement & Battery Back up if 120 volt
If no fan control module or AC adaptor is installed, 4 AA batteries are mandatory in the remote receiver to operate the appliance when using
power is lost witihin home
the remote control.
How to replace/add the batteries on remote receiver (Proflame 1).
Note : If a wall switch cover plate is installed, first remove cover plate by removing 2 small phillips head screws
STEP 1
STEP 2
STEP 3
STEP 4
Reinstall wall cover plate with 2 Phillips head screws.
Move both the left/right slides
as shown below.
Extract the battery
compartment from the remote
receiver/battery holder
Keeping the battery compartment
pressed in, close the left slide
The battery compartment
will be pushed out slightly,
to allow to easily extract it
Replace 4 x AA batteries and insert the battery
compartment back into remote receiver/battery holder
Close the right slide
P36E-11 Zero Clearance Direct Vent Gas Fireplace
installation
| 17