Tunturi C55-F User Manual page 24

English
- Keep clothing, jewelry and other objects away from
the moving parts.
- Make sure that only one person uses the equipment
at a time. The equipment must not be used by
persons weighing more than 120 kg (264 lbs).
- Do not open equipment without consulting your
dealer.
Electrical safety
(Only for equipment with electric power)
- Before use, always check that the mains voltage is
the same as the voltage on the rating plate of the
equipment.
- Do not use an extension cable.
- Keep the mains cable away from heat, oil and sharp
edges.
- Do not alter or modify the mains cable or the mains
plug.
- Do not use the equipment if the mains cable or the
mains plug is damaged or defective. If the mains
cable or the mains plug is damaged or defective,
contact your dealer.
- Always fully unwind the mains cable.
- Do not run the mains cable underneath the
equipment. Do not run the mains cable underneath
a carpet. Do not place any objects on the mains
cable.
- Make sure that the mains cable does not hang over
the edge of a table.
- Make sure that the mains cable cannot be caught
accidentally or tripped over.
- Do not leave the equipment unattended when the
mains plug is inserted into the wall socket.
- Do not pull the mains cable to remove the mains
plug from the wall socket.
- Remove the mains plug from the wall socket when
the equipment is not in use, before assembly or
disassembly and before cleaning and maintenance.
Assembly instructions
Description (fig. A)
Your Crosstrainer is a piece of stationary fitness
equipment used to simulate cycling without causing
excessive pressure to the joints.
Package contents (fig. B & C)
- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in fig.
C. Refer to the section "Description"
‼ NOTE
• If a part is missing, contact your dealer.
Assembly (fig. D)
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two
persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
• Refer to the illustrations for the correct assembly
of the equipment.
‼ NOTE
• Save the tools provided with this product, after
you completed the product assembly,
for future service purposes.
Fasten Nuts and Bolts
NOTE: Do not over tighten any component with
pivoting function. Make sure all pivoting components
are able to move freely.
DO NOT FASTEN BOLTS
AND NUTS IN THIS STEP
Workouts
The workout must be suitably light, but of long
duration. Aerobic exercise is based on improving
the body's maximum oxygen uptake, which in turn
improves endurance and fitness. You should perspire,
but you should not get out of breath during the
workout.
To reach and maintain a basic fitness level, exercise at
least three times a week, 30 minutes at a time. Increase
2 4
Securely tighten all Nuts and
Bolts after all components have
been assembled in current and
previous steps.
Do not tighten all Nuts and Bolts
in this step.