Rf Signal Conversion; Figure 1-3. Typical Functional Block Diagram (Ut-4512 Shown) - Comtech EF Data UT-4579 Installation And Operation Manual

UT-4579 X-Band Up Converter MN/UT4579.IOM
Introduction Revision 1
The BU performs fault detection, self-reconfiguration, and logical switching
functions. If the BU has a fault, it is prevented from performing the protection-
switching task. If the BU does not have a fault, it assumes the frequency and
attenuation of the faulted online converter, and compensates for the chain
losses.
Changes in frequency, attenuation or polarity are entered into the backup table
as they are made, as well as information from new online units. The HSB does
not interfere with the remote control communications link for access to any of
the converters in the "Daisy Chain".

1.2.2 RF Signal Conversion

Figure 1-3. Typical Functional Block Diagram
Figure 1-3 depicts the operational schematic for the UT-4579 Up Converter in
single thread (standalone) applications. See Appendix A. REDUNDANT SYSTEM
1–4