If the configuration program detects that all ServeRAID controllers in the server are configured, the
program starts in the Information mode and a screen similar to the following appears.
Figure 6. Information mode screen
Click
on the tool bar to switch from the Information mode to the Configuration mode.
2. Continue with one of the following:
"Using the Configuration mode."
"Using the Information mode" on page 28.
Using the Configuration mode
You can use the Configuration mode to create up to eight independent disk arrays for each ServeRAID
controller. The Configuration mode provides two configuration paths: Express configuration and Custom
configuration (see Figure 5 on page 20).
5
KB equals approximately 1000 bytes.
Chapter 3. Configuring controllers using the ServeRAID Manager program
21