Table of Contents
Advertisement
h
h
h
+
1. When checking the needle, or performing the feed forward or backward, the
machine fails to work unless the presser is lowered. Use the machine after
lowering the presser.
2. When increasing the height of intermediate presser or making the needle size
thicker, confirm the clearance between the wiper and the components. Wiper
cannot be used unless the clearance is secured. In this case, turn OFF the wiper
switch, or change the set value of memory switch
• C h a n g i n g t h e i n t e r m e d i a t e p r e s s e r
reference value
1)
Press
key in the ready state to select
the intermediate presser.
2)
Press
key for 5 seconds or more with
the feeding frame lowered.
3)
The sewing LED lights up and the
intermediate presser LED flashes on and off.
4)
Set the intermediate presser reference value
with
key or
• C h a n g i n g t h e i n t e r m e d i a t e p r e s s e r
command value
1)
Press
key in the aforementioned
reference value change state.
2)
Both the sewing LED and the intermediate
presser LED flash on and off.
3)
Continue stitching with
4)
"C" is displayed when there is the
intermediate presser command in the current
needle entry point.
5)
Pressing
presser command value with
key.
6)
When ending the setting, press
– 83 –
key.
key or
key, set the intermediate
key or
key.
.
key.
Advertisement
Table of Contents
