JUKI AMS-210E-1306 Instruction Manual page 40

F
1. When turning OFF the power without pressing READY key
"Pattern No.", "X enlargement/reduction ratio", "Y enlargement/reduction ratio",
"Max. sewing speed", "Thread tension" or "Intermediate presser height" is not
stored in memory.
2. In case thread tension is changed in the read state, the set value when the power
is turned OFF without pressing READY key or without performing sewing is not
stored in memory.
3. When operation processing cannot be performed since the reduction ratio is
excessively small, E045 Pattern data error is displayed.
H
For example, input X scale rate.
Press A to display the item data input screen.
3 Input the data.
Input the value you desire with ten keys and + / – keys F .
4 Determine the data.
When ENTER button
determined.
* For the other item data, the data can be changed by the same
G
operation.
* It is possible to input X/Y value of enlargement/reduction ratio
and actual size value with one screen.
When X/Y enlargement/reduction ratio, thread tension, intermediate
presser, adding/deleting of thread tension command, or adding/
deleting of increase/decrease value of intermediate presser of
users' pattern or smart media pattern is performed, the pattern kind
section becomes change display H .
In case of change display H , the change confirmation screen is
displayed at the time of the change of pattern.
When ENTER button
current pattern is invalidated and the pattern No. is changed.
To store the changed pattern, refer to
register of users'
I
– 36 –
G is pressed, the data is
I is pressed, the information on the
"@-2-13. Performing new
pattern".
, the set value of