Table of Contents
Advertisement
(2) Replenishing the oscillator pin section with grease
3
(3) Grease supplement to the face plate section
(4) Grease supplement to X guide shaft bearing
2
1
2
1
4
5
4
– 121 –
1)
Tilt the machine head and remove the grease
cover 1 .
2)
Fill joint 4 supplied as accessories with
grease from the grease tube.
3)
Remove setscrew 3 in oscillator gear 2 and
screw in joint 4 into the screw hole.
4)
Screw in screw 5 supplied as accessories to
the joint and replenish there with the grease.
5)
Securely tighten setscrew 3 which has been
removed after replenishing with the grease.
1)
Open the face plate cover.
2)
Supplement grease to the felt section (3
places) and the hinge screws around them.
1)
Apply grease to X guide shaft 1 and the rear
of presser plate 2 .
Advertisement
Table of Contents
