Connecting The Cord - JUKI AMS-210E-1306 Instruction Manual

3-11. Connecting the cord

1
Slowly
2
C
1
B
How to lock the cord clamp
1 Lightly press
the corner
of clamp.
(Cord clamp is
locked with a
click.)
When fixing the cord with the cord clamp, be careful of the route or the like so that
the stress is not applied to the cord.
A
1
1
2
Clamp
[How to open the control box]
Remove four screws 1 fixing the rear cover of
the electrical box. When opening the rear cover,
pressing it with your hands, slowly open it by
approximately 90˚ until it stops as illustrated.
Be sure to lend your hand to the
rear cover in order not to let the rear
cover fall. In addition, do not apply
force to the rear cover opened.
[How to close the control box]
1) Take care so that the cord is not
caught between the rear cover and
the electrical box main body, close the
rear cover while pressing section A on
the lower side of the rear cover, and
tighten four screws 1 .
2) Lower downward the cord located on
the side of the control box and cord
presser plate C in the push hole B,
press the cord and tighten screws 2 .
How to remove the cord clamp
1
– 9 –
1 Lightly pressing
2 Pull down the clamp.
3 The clamp goes up.
2
3
1