TANDBERG Media Processing System MPS 200 Administrator's Manual page 96

G.703 Board
G.703 Board Interfaces (2:2)
PRI Board Configuration
Please ensure that Network Type
!
PRI Network Configura-
the correct ISDN cards in the
tion .
G.703 Board
Leased Line is a non-dialling protocol. Should be used when:
1. One codec is connected in a point to point connection
2. Through an ISDN switch supporting G.703 Leased Line
mapping.
Channel (1 to 5)
For each G.703 Leased Line interface it is possible to
define one or more calls. Each call is identified by a number
("call-id"), a start channel and max number of channels. The
maximum number of possible calls is 5.
Start Channel (1 to 5) Max Channels (1 to 5)
E1: Start channel <1..31> Max channels <0 (Off), 1..31>
T1: Start channel <1..24> Max channels <0 (Off), 1..24>
Table: Example with four different call settings:
5 Calls 4 Calls
Start Channel 1 1 1
Max Channels 1 4 (256 k) 6 (384 k)
Start Channel 2 5 7
Max Channels 2 4 (256 k) 6 (384 k)
Start Channel 3 9 13
Max Channels 3 4 (256 k) 6 (384 k)
Start Channel 4 13 19
Max Channels 4 4 (256 k) 6 (384 k)
Start Channel 5 17
Max Channels 5 4 (256 k)
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
is set to G.703 for
3 Calls 2 Calls
1 1
8 (512 k) 12 (768 k)
9 13
8 (512 k) 12 (768 k)
17
8 (512 k)
Quick
Installation
Setup
Network Configuration
Save
- Press the Save button to save changes.
System
Using System
Configuration
the MPS Status
96
Gateway MCU Technical
Configuration Configuration Descriptions
TANDBERG MPS
ADMINISTRATOR GUIDE
Appendices
MPS