Isdn Pri Board Status - TANDBERG Media Processing System MPS 200 Administrator's Manual

System Status

ISDN PRI Board Status

ISDN PRI Board Status
If a PRI cable is disconnected or malfunctioning, or
basic configuration is erroneous,
•
Red Alarm is displayed in red for the affected
interfaces.
•
Sync alert is displayed in red for the affected
interfaces.
If a participant has been disconnected, the cause
code can be viewed by pressing the link next to the
disconnected PRI channel.
The most common cause codes (for ISDN):
1 Unallocated (unassigned) number
2 No route to specified transit network (WAN)
16 Normal call clearing
17 User busy
18 No user responding
21 Call rejected
28 Invalid number format (incomplete number)
29 Facilities rejected
31 Normal, unspecified
34 No Circuit/Channel Available
41 Temporary Failure
58 Bearer Capability Not Presently Available
65 Bearer Capability Not Implemented
69 Requested Facility Not Implemented
81 Invalid Call Reference Value
88 Incompatible Destination
100 Invalid Information Element Contents
102 Recovery On Timer Expiry
127 Interworking, Unspecified
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
ISDN PRI Board Status
Quick Using
Installation
Setup the MPS
System
System
Status
Configuration Configuration
77
ADMINISTRATOR GUIDE
Gateway MCU Technical
Configuration Descriptions
TANDBERG MPS
Appendices
MPS