Table of Contents
Advertisement
Conference Template
Video Settings (2:5)
Conference Template Configuration
The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.
The conference template contains the same settings as de-
scribed in the
Create Conference
CP Autoswitching
The CP Autoswitching enables to swap non speaking sites with the
least active sites in the picture. This lets you see all participants in a
conference, even if they are not speaking.
CP Autoswitching can be set to a value between
60 seconds
and
. The number of seconds denotes how long each of
the remaining participants shall be displayed on the screen.
If set to
0 seconds
the CP Autoswitching will be disabled.
Note that the CP Autoswitching will be performed in another picture if
one or more of the participants speak.
Video Format
Video Format
Defines the video format for Continuous Presence mode.
Defines the video format for Continuous Presence (CP) mode.
Auto
TF
In Full Screen Voice Switched Conference layout, the MCU will priori-
(Best Impression
) In Continuous Presence mode the MPS will
select Motion (CIF) if the call rate is below 256 kbps and sending
tize H.264 CIF as the highest common format.
4:3 aspect ratio. When sending 16:9 aspect ratio the MPS will select
Auto
(Best Impression
TF
) Set to Auto to automatically select the most
Motion (w288p) if the call rate is below 512 kbps. At call rates of 256
suitable video format depending on the Conference Layout used in
kbps and higher the MPS will select Sharpness (4CIF) when sending
the conference. In Full Screen Voice Switched, the MCU will select
4:3 aspect ratio. When sending 16:9 aspect ratio the MPS will select
Motion (CIF) displaying up to 30 frames per second (fps). In Continu-
Sharpness (w576p) at call rates of 512 kbps and higher.
ous Presence mode the MCU will select Motion (CIF) if the call rate is
Motion:
below 256 kbps and Sharpness (4CIF) when the call rate is 256 kbps
Set to Motion to prioritize motion and show up to 30 fps in CIF resolution
and transmit the highest common format, preferably H.264 CIF when sending 4:3
or higher.
aspect ratio or H.263+ w288p when sending 16:9 aspect ratio.
Motion:
Set to Motion to prioritize motion and show up to 30 fps in
Sharpness:
CIF resolution and transmit the highest common format, preferably
Set to Sharpness to prioritize crisp and clear picture and transmit the
H.264 CIF.
highest common format, preferably H.263+ 4CIF when sending 4:3 aspect ratio or
H.263+ w576p when sending 16:9 aspect ratio.
Sharpness:
Set to Sharpness to prioritize crisp and clear picture and
In Full Screen Voice Switched Conference layout, the MCU will prioritize H.264 CIF as
transmit the highest common format, preferably H.263+ 4CIF.
the highest common format.
Table of
Main
Introduction
Contents
D 13373.08
NOVEMBER 2007
in the Overview section.
0 seconds
(default)
Quick
Installation
Setup
Conference Template Configuration
Video Custom Formats
On:
Set to On to support custom formats, such as SIF and
VGA resolutions. It allows true resolution to be maintained,
rather than being scaled to another format. This is of particu-
lar benefit to users of NTSC and VGA resolutions, ensuring
that their images are not scaled to fit with the PAL standard.
Off:
Set to Off when support for custom formats are not
needed.
Using
System
the MPS
Status
Configuration
134
Press
MCU
System
Gateway
Configuration
Configuration
TANDBERG
MPS
ADMINISTRATOR GUIDE
Save
to activate the new settings
Technical
Appendices
Descriptions
MPS
- Quick Links:
- Mps 800 with 8 Media Processing...
Hide quick links:
Advertisement
Table of Contents
