Participants Settings - TANDBERG Media Processing System MPS 200 Administrator's Manual

MCU Overview > Create Conference

Participants Settings

Video Participant Limit
Defines the maximum number of Video Participants allowed in
the conference and reserves the number of needed
Video Option ports for this conference.
Values: 0 - 40 for MPS 200 and 0 - 160 for MPS 800.
Telephone Participant Limit
Defines the maximum number of Telephone Participants al-
lowed in the conference.
Values: 0 - 32 for MPS 200 and 0 - 48 for MPS 800.
Welcome Picture and Sound
On:
When set to On a Welcome screen and audio message
will be shown to each new participant of the conference.
Off: Set to Off to disable the Welcome screen and audio mes-
sage.
Entry and Exit Tones
On: When set to On a tone signal will be heard each time a
participant is entering or leaving the conference.
Off:
Set to Off to disable the Entry and Exit Tones.
Timeout Participants from Call List
On:
When set to On all participants that have been discon-
nected from the conference will be cleared from the Call List
within 2 minutes.
Off:
Set to Off to disable the Timeout Participants from Call
List.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
Advanced
Create Only
Select Create Only to create a confer-
ence, with the above-specified configura-
tion, without dialling out to any partici-
pants.
Using
Quick
Installation
the MPS
Setup
Add Participants
Select Add Participants to add participants
or to manually dial a participant.
System System
Status Configuration Configuration
50
ADMINISTRATOR GUIDE
Cancel
Select Cancel to discard all changes and
Conference Overview
return to the
Gateway MCU Technical
Configuration Descriptions
TANDBERG MPS
page.
Appendices
MPS