G.703 Board; G.703 Board Interfaces (1:2) - TANDBERG Media Processing System MPS 200 Administrator's Manual

G.703 Board

G.703 Board Interfaces (1:2)

PRI Board Configuration
Please ensure that Network Type
!
PRI Network Configura-
the correct ISDN cards in the
tion .
G.703 Board
Leased Line is a non-dialling protocol. Should be used when:
1. One codec is connected in a point to point connection
2. Through an ISDN switch supporting G.703 Leased Line
mapping.
NOTE! It may be necessary to specify the call rate explicitly
when dialling a G.703 call id to ensure that the correct call
rate is used.
Slot (1 to n)
1 6
Select Slot to to configure the G.703 (Leased Line) board.
The picture shows one G.703 board installed in Slot 3.
Indicates ok Indicates an error
Physical Layer
Select E1 (max 30+1 channels) or T1 (max 23+1 channels) to
match your ISDN network.
Interface (1 to 8)
The interface number refers to the port number/G.703 inter-
face of the Network Interface Card.
Enable
On: If set to On, the port is enabled for G.703 use.
Off: If set to Off, the port is disabled for G.703 use.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
is set to G.703 for
Quick
Installation
Setup
Network Configuration
Save
- Press the Save button to save changes.
System
Using System
Configuration
the MPS Status
95
Gateway MCU Technical
Configuration Configuration Descriptions
TANDBERG MPS
ADMINISTRATOR GUIDE
Appendices
MPS