TANDBERG Media Processing System MPS 200 Administrator's Manual page 135

Conference Template
Video Settings (3:5)
Conference Template Configuration
The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.
The conference template contains the same settings as de-
scribed in the Create Conference
Dual Video Stream
The MCU supports DuoVideo TF , H.239 and BFCP.
On: Set to On to enable Dual Video Stream for this conference. Both
TF
DuoVideo , H.239 are supported in the same conference.
Off:
When set to Off, Dual Video Stream will not be supported in this
conference.
Conference Selfview
On:
Set to On to enable Conference Selfview. The user will see
himself in the picture when more than one participant is in the confer-
ence.
Off:
Set to Off to disable Conference Selfview.
Telephone Indication
On:
Set to On to enable a Telephone Indicator to be displayed when
there are telephone (audio only) participants connected to the confer-
ence. When the telephone participant is speaking the indicator will be
outlined.
Off: Set to Off to disable the Telephone Indicator to be displayed.
Speaker Indication
On:
Set to On to enable a Speaker Indicator (a coloured line) to be
displayed around the sub-picture that will indicate who is the currently
speaking participant.
Off:
Set to Off to disable the coloured line to be displayed.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
in the Overview section.
Quick
Installation
Setup
Conference Template Configuration
Lecture Mode
On:
Set to On to enable the Lecturer to be displayed in full
screen to the other participants.
•
The Lecturer is the participant which is assigned floor.
•
The Lecturer will see a scan of all the participants in a full
screen view or one of the supported sub-picture views.
Off:
Set to Off to disable the Lecturer, the participant which is
assigned floor, to be view in full screen.
Using System
the MPS Status Configuration
135
Press
MCU
System Gateway
Configuration
Configuration
TANDBERG MPS
ADMINISTRATOR GUIDE
Save to activate the new settings
Technical
Appendices
Descriptions
MPS