TANDBERG Media Processing System MPS 200 Administrator's Manual page 37

MCU Overview
MCU Usage Information
The General field displays some basic informa-
tion:
•
Software version
•
IP address(es)
•
Gatekeeper address and status
•
SIP status
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
MCU Usage Information
The Status field displays the connections status
for the installed boards and cards:
•
Media boards
•
ISDN PRI card
•
ISDN G.703 card
•
SERIAL card
Indicates OK
Indicates an error
More
Click to see more details.
Using
Quick
Installation
the MPS
Setup
The Usage pane for MCU calls shows the current status of all the available resources (Video,
Telephone, ISDN Channels and Total Bandwidth).
Right above the Usage pane you can:
•
Set Auto-Refresh to On/Off
•
Adjust the Refresh Rate (2-30 seconds)
•
Refresh
For a quick refresh click the
The status of the MCU resources:
•
Telephone Calls 0 of 32:
indicate that 0 telephone calls are connected to the MCU. The
total number of supported telephone calls in this configuration is 32.
•
Video Calls 0 of 40:
indicate that 0 video calls are connected to the TANDBERG MPS. The
total number of supported video calls in this configuration is maximum 40.
•
ISDN Channels 0 of 45:
indicate that 0 ISDN channels are used on the TANDBERG MPS.
The total number of supported ISDN channels in this configuration is 45.
•
Total Bandwidth 0 of 43200:
MPS. The maximum bandwidth available in this configuration is 43200 kbps.
•
Conferences 0 of 15: indicate that there are up to 15 available conferences on this TAND-
BERG MPS, and that 0 of them are currently in use.
System System
Status Configuration Configuration
37
ADMINISTRATOR GUIDE
button.
indicate that 0 kbps bandwidth is used on the TANDBERG
Gateway MCU Technical
Configuration Descriptions
TANDBERG MPS
Appendices
MPS