D 13373.08 November; Starting The System - TANDBERG Media Processing System MPS 200 Administrator's Manual

Installation

Starting the System

Starting the System
Preparations
Before starting the TANDBERG MPS make
sure the following has been done:
System Controller Board
1. The must be
installed in the first slot in the chassis.
Make sure the Media Processing Board(s)
2.
Network Interface Card(s)
and the are
interted correctly into the chassis.
MPS 800: Make sure the Power Unit(s)
2.
are inserted correctly into the back of the
chassis.
Connect the Power Cable .
3.
Turning on the MPS
Set the Power Switch on the back of the
1
chassis to .
Startup mode
•
On the front of the chassis you will see the
CPU LED
on the System Controller Board
flashing
•
On the Media Processing Boards the
Power
LED turns green.
•
Active
The LED is flashing green while
software is being uploaded to the Media
Processing Boards.
•
LCD
In the (Liquid Crystal Display) you will
see the logo.
The system is ready for configuration
Power Active
1. When both and LED's on the
Media Processing Boards are steady green
And the initial configuration menu appears
2.
on the LCD.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
MPS200 Front Side
Liquid Crystal
Display
CPU LED
Power LED
Active LED
MPS800 Front Side
Liquid Crystal
Display
CPU LED
Power LED
Active LED
Quick Using
Installation
Setup the MPS
Power
Switch
System System
Status Configuration Configuration
26
ADMINISTRATOR GUIDE
MPS200 Back Side
MPS800 Back Side
Power
Cable
Gateway MCU Technical
Configuration Descriptions
TANDBERG MPS
Power
Switch
Power
Cable
Appendices
MPS