TANDBERG Media Processing System MPS 200 Administrator's Manual page 57

MCU Overview > Manage an Active Conference
Add Participants (3:3) - Manual Dialing (2:2)
Conference Status
The Conference Status page shows information about a con-
ference and lets you control the conference.
Dial Profile
Select which dial profile to use for this phone book entry.
Auto:
The MPS will automatically select the appropriate profile
ISDN: ISDN will always be used for dialling.
H.323: IP will always be used when dialling.
SIP: SIP will always be used when dialling.
If defined, custom Dial Profiles (Network Profiles) will show in
the list. See MCU Configuration for more information.
Subaddress
The Subaddress is used to address different participants on
the same ISDN line or TCS4 dialling.
DTMF String
Specify the DTMF (Dual Tone Multi-Frequency) or Touch Tone
string.
Network Module
Specify which Network Interface Card to use for outgoing
calls. Enter a value between 0 and 6.
•
Optional for ISDN calls
•
Mandatory for V.35 calls and G.703 Leased Line calls.
Network ID
Used to identify port or interface number within a network
module. Enter a value between 1 and 32:
•
Specify which IP network to use, only
values (optional).
•
Specify which V.35 port to use (mandatory).
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
1 and 2 are valid
Quick
Installation
Setup
Using
System System
the MPS
Status Configuration
57
Gateway MCU Technical
Configuration Configuration Descriptions
TANDBERG MPS
ADMINISTRATOR GUIDE
Appendices
MPS