TANDBERG Media Processing System MPS 200 Administrator's Manual page 177

MS Live Communications Server
Configuring LCS and MPS for SIP (5:6)
Configuring the MPS
The Microsoft Live Communication Server (LCS) should be config-
ured prior to the MPS unit.
The MPS configuration consists of ensuring the MPS has a valid DNS
name server configured and entering the LCS server information.
DNS Server Configuration
The LCS SIP operation requires the MPS to have a valid DNS (Domain
Name System) server configured.
If the DNS server is not configured properly, calls may connect to
!
the MPS, but neither video nor audio will be transmitted to the far
end.
SIP Configuration
To configure the MPS for SIP communication, navigate to System Con-
figuration > SIP:
SIP Mode On
1. Set to
Configure the Interface for SIP communication. Enter the
2.
IP Address
or for the SIP server in the Address field and set the SIP
Server Type to Microsoft
Save restart
3. Press the button and the MPS for all changes to take
affect.
Please refer to section System Configuration > SIP Configuration
for more details.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
MPS SIP Configuration
DNS Name
Quick Using
Installation
Setup the MPS
System System
Status Configuration
177
Gateway MCU Technical
Configuration Configuration Descriptions
TANDBERG MPS
ADMINISTRATOR GUIDE
Appendices
MPS