Simple Pri Configuration - TANDBERG Media Processing System MPS 200 Administrator's Manual

Initial Configuration (3:4)

Simple PRI Configuration

Configuration of the MPS using Web Interface
Open a web browser and type in the IP address to
access the web interface. The IP address to enter
was configured from the LCD during the installation
process.
Simple PRI Configuration
Navigate to System Configuration > PRI:
•
Switch Type
Set by selecting the apropriate PRI
protocol: National ISDN, AT&T Custom ISDN, ETSI
(Euro ISDN) or Japan/Taiwan ISDN.
All PRI lines on the same E1/T1 Interface Card
must use the same PRI Protocol.
•
If same number for all PRI's set Trunk Groups
to On.
•
Configure PRI Numbers in Number Range Start
Number Range Stop
and .
Please refer to section System Configuration
> PRI Board Configuration for details.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
Simple PRI Configuration

Quick
Using
Installation
Setup
the MPS
Save - Press the Save button to save changes.
System System
Status Configuration
34
Gateway MCU Technical
Configuration Configuration Descriptions
TANDBERG MPS
ADMINISTRATOR GUIDE
Appendices
MPS