TANDBERG Media Processing System MPS 200 Administrator's Manual page 176

MS Live Communications Server
Configuring LCS and MPS for SIP (4:6)
Configuring the MPS
The Microsoft Live Communication Server (LCS) should be config-
ured prior to the MPS unit.
The MPS configuration consists of ensuring the MPS has a valid DNS
name server configured and entering the LCS server information.
DNS Server Configuration
The LCS SIP operation requires the MPS to have a valid DNS (Domain
Name System) server configured.
If the DNS server is not configured properly, calls may connect to
!
the MPS, but neither video nor audio will be transmitted to the far
end.
DNS Configuration
To configure the DNS server on the MPS, navigate to System Configura-
tion > IP:
Locate the configuration for the particular Service Controller Interface
the system will use and enter the IP Address
Server (DNS) Interface 1. Up to five DNS addresses can be configured.
SIP is only supported on DNS Interface 1.
Please refer to section System Configuration > IP Configuration
more details.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
of the Domain Name
for
Quick
Installation
Setup
MPS DNS Configuration
Using System System
the MPS Status Configuration
176
Gateway MCU Technical
Configuration Configuration Descriptions
TANDBERG MPS
ADMINISTRATOR GUIDE
Appendices
MPS