AGFA DX-G User Manual page 39

4. Plug the power plug into the socket.
Switch on the UPS, if installed.
Cleaning the touch panel
To clean the touch panel:
1. Switch off the digitizer.
2. Remove the power plug from the socket.
Switch off the UPS, if installed.
3. Wipe the touch panel of the digitizer with a clean, soft, damp cloth. Use a
commercially available screen cleaner for monitors to clean the touch
panel.
4. Plug the power plug into the socket.
Switch on the UPS, if installed.
Cleaning the optical unit
The only maintenance action which you must perform is checking the image
quality. Refer to the User Manual of the NX Software.
WARNING:
Make sure no liquid gets in the device.
CAUTION:
Do not open the digitizer for cleaning. No components inside
the digitizer require cleaning by the user.
WARNING:
Do not pour liquid directly on the touch panel.
WARNING:
Dust in the optical unit on the light collecting mirror can create
stripes parallel to the image plate movement within the
digitizer. When you recognize this type of artefact, when using
the digitizer, clean the optical unit using the cleaning brush.
DX-G, DX-M | Introduction | 39
2321G EN 20181126 1428