Safety Instructions For Laser Products - AGFA DX-G User Manual

36 | DX-G, DX-M | Introduction

Safety Instructions for Laser Products

The digitizer is a Class 1 Laser Product. It uses one laser diode of a 80 mW
type, classification class IIIb, wavelength 640-670 nm. The laser beam's
deflection frequency is 80 1/s up to 170 1/s. The laser beam divergence is
12mrad.
Under normal operating conditions - device with all covers - there can be no
laser radiation outside the digitizer.
The technical concept does not allow the user to remove the top cover.
However, the user is allowed to open the side cover, e.g. to clean the optical
unit or to change an air-filter. When opening the side panel, all motor driven
system movements will be stopped (including the laser).
2321G EN 20181126 1428
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
LASERKLASSE 1
CAUTION:
User interventions other than those described in this
manual can be hazardous with regard to laser radiation.
CAUTION!
CLASS 3B LASER RADIATION:
WHEN OPEN AVOID DIRECT EVITAR LA EXPOSICIÓN AL HAZ
EXPOSURE TO THE BEAM! CUANDO LA TAPA EST Á ABIERTA.
VORSICHT !
LASERSTRAHLUNG KLASSE 3B: FAISCEAU LASER CLASSE 3B:
WENN ABDECKUNG GEÖFFNET QUAND CAPOT OUVERT ÉVITER
NICHT DEM STRAHL AUSSETZEN! DE S´EXPOSER AU RAYÓN!
CUIDADO!
RAYO LASER CLASE 3B:
ATTENTION!