Installation - AGFA DX-G User Manual

Installation

Digitizer installation and configuration is performed by an Agfa certified
service engineer.
The digitizer is foreseen to be installed in a stationary and weather protected
location.
In case of an installation in a mobile environment, such as a bus, van, etc, the
manufacturer of the vehicle should ensure that all components of the system
are fixed or can be fixed safely for transport. There is a mobile version of the
digitizer available that provides externally accessible locking systems for the
fixation of the mechanics inside the device.
CAUTION:
Excessive light falling on the digitizer during operation may
create image artefacts leading to retakes. Do not expose the
digitizer to direct sunlight, max. 2500 Lux.
WARNING:
Do not apply excessive shock or vibration to the digitizer during
operation. This may decrease the image quality. Neither should
the device be moved during operation.
WARNING:
Mechanical shocks or external vibration applied to the digitizer
during mobile use or transport degrades image quality and may
lead to retakes. Take care not to exceed the specified vibration
conditions.
WARNING:
Failure of a protective earth connection can increase the risk of
electric shock. Regularly check the connections of the protective
earth connection of the mains plug. It is recommended to use
and regularly check the second protective earth connector.
WARNING:
Agfa recommends the installation of a UPS (uninterruptible
power supply) for the digitizer to overcome power failures of the
hospital power network and to prevent a resulting image-loss.
CAUTION:
The digitizer and the cassette storage shall be protected against
direct radiation in such a way, that the annual dose equivalent
at the place of installation will not exceed 1 mSv/a.
CAUTION:
When installing the digitizer, care must be taken to ensure that
there is either a mains plug or an all-cable disconnecting device
in the internal installation fitted near the digitizer and that it is
easily accessible.
DX-G, DX-M | Introduction | 19
2321G EN 20181126 1428