Configuration - AGFA DX-G User Manual

Configuration

The digitizer is part of a CR system that has the following configuration:
• The digitizer, a digitizer for scan of image plates retaining latent X-ray
images. The digitizer accepts multiple cassettes at a time, to be scanned
sequentially.
• The NX workstation, one or more CR workstations with ID Tablet for
cassette identification, image processing and image transmission of
digitized images received from the digitizer.
• Cassette and plate system: CR HD5.x General, CR HD5.x FLFS, CR HD5.x
AEC, CR HD5.x Extremities, CR MD4.xR General and CR MD4.xR FLFS.
• For DX-M additionally, CR HM5.x Mammo or CR MM3.xR Mammo - mixed
use of both types in one digitizer will not be supported.
• The CR HD5.x General detector, CR HD5.x FLFS detector, CR HD5.x AEC
detector, CR HD5.x Extremities detector, CR MD4.xR General plate and
cassette, CR MD4.xR FLFS plate and cassette, CR HM5.x Mammo detector
and CR MM3.xR Mammo plate and cassette are generically referred to as
'plates and cassettes'.
Note: The use of CR HD5.0 Extremities cassettes requires a
software version ≥ NIM_2501.
Note: For US DX-M is released in combination with CR HM5.x
Mammo detectors only.
DX-G, DX-M | Introduction | 11
2321G EN 20181126 1428