• initialization of all components,
• functional test of all components,
• check for presence of cassettes and/or IPs.
During the warm-up and self-test, which may take up to 3 minutes, the
digitizer status indicator is flashing red.
Note:
During the self-test, you cannot activate any functions.
If the digitizer has completed the self-test successfully, the digitizer enters
the operator mode and the status indicator is continuously lighting up in
green. The Standby screen is shown:
Note:
The brightness of the touch panel is temporarily reduced after
not being used for a while.
DX-G, DX-M | Getting started | 59
2321G EN 20181126 1428