Unlocking The Digitizer After Transport - AGFA DX-G User Manual

28 | DX-G, DX-M | Introduction

Unlocking the digitizer after transport

To unlock the digitizer after transport:
1. Insert the locking tool in the round opening in the front cover.
2. Push the tool towards the end and turn it counterclockwise till mechanical
resistance can be felt.
3. On the right side of the digitizer, turn the two handles 180°
counterclockwise till they reach the unlocked position:
4. Repeat the same using the two handles on the left side of the digitizer.
5. Switch on the digitizer.
2321G EN 20181126 1428
Note:
If the digitizer is switched on without removing the transport lock
on the front side, the following warning message is displayed: